Blockbit connection with zabbix

Conexão do blockbit com zabbix

Neiffson · 2025-04-02T14:35:34+00:00

Olá comunidade, queria tirar uma dúvida, ativei meu SNMP no Blockbit, mas estou com dificuldade em conectar ele no zabbix, quais parâmetros devo usar?

Neiffson

Hello community, I wanted to ask you a question, activated my SNMP on Blockbit, but I'm having trouble connecting it to zabbax, which parameters should I use?

Icaro Rocha

On the screen you sent, only set the "SNMP Community". This field works as an identifier, and you can set a custom community or use the default, which is "public".

In addition to registration at Zabbix, it is essential to activate the service at Blockbit. To do this, use the command: enable-snmp via CLI.

You also need to set up Zone Protection to allow SNMP traffic from the network where Zabbix is located.

For more details see: https://docs.blockbit.com/display/RC/Zabbix

If you need any more guidance, I'm at your disposal!

Neiffson

Icaro Rocha How do I define the community?

Icaro Rocha

Neiffson

In Zabbix, in the "SNMP Community" field, remove the current content and enter the desired community, such as "ctc" or the "public" pattern. Any string can be used.

NGFW Host Blockbit Configuration in Zabbix

And in Blockbit as shown below:

SNMP Configuration in Blockbit NGFW via CLI

And finally:

Entry rule in Blockbit NGFW

Neiffson

Icaro Rocha Would IP be Blockbit's main interface?

Neiffson

I checked the community, the connection was successful, thank you very much!