How to configure snmp monitoring in Blockbit

Como configuro monitoramento snmp no Blockbit

Ariel Prado · 2024-04-22T14:49:51+00:00

Realizei o download do template oficial da Blockbit para Zabbix, importei no meu Zabbix certinho. Porém ainda não achei onde configuro no NGFW para que o za...

Ariel Prado

I downloaded the official Blockbit template to Zabbix, imported it into my right Zabbix.

But I still haven't found where to set up at NGFW so the zabbabix can collect his information.

You could help me.

Acélio Carvalho

Ariel Prado

Hello Ariel, if the host with Blockbit IP is already registered in Zabbix, you need to enable the SNMP service in Blockbit NGFW using the command enable-snmp CLI.

 admin  >enable-snmp
 Enable SNMPv1 (Y/N)? N
 Enable SNMPv2 (Y/N)? Y
 Community name: [COMUNIDADE]
 Network Access (Leave blank to default 0.0.0.0/0): [ENTER]
 Enable SNMPv3 (Y/N)? N
 Confirm (Y/N)? Y

After configuring the SNMP service, it is necessary to enable the SNMP service entry policy in [Services > Firewall > Zone Protection].

By default, access is allowed to the LAN network area. However, if the Zabbix server is in another network area, adjustments will be required.

Joe

admin >enable-snmp
Enable SNMPv1? N
Enable SNMPv2? Y
Community name: [COMMUNITY]
Network Access (Leave blank to default 0.0.0.0/0): [ENTER] (Galera how to add more than one network scope? or two distinct monitoring IPs in this Network Access field)
Enable SNMPv3? N
Confirm? Y

Icaro Rocha

Joe

To work this way you must leave the default network 0.0.0.0/0 in the service configuration itself and restrict by source in the SNMP input rule.

This way: